1. Input the water into the tank when there is water but not full in the tank, input the water into the tank in time when the tank is empty. Don’t input water if the empty tank is shined for more than 15 minutes. Input water in the evening or next morning to protect the vacuum tube from big temperature difference.
2. Prevent from scalding yourself by hot water while bathing. Turn on cold water gate valve firstly, turn on hot water gate valve secondly, then adjust water temperature and volume.
3. Make the water tank full before using the assistant electric heater, heating without water is strictly prohibited. For the sake of security, switch off the power first, and then use the water.
4. Please turn down the input gate valve while inputting the water into the high water pressure area, infuse water into the tank slowly to prevent the vacuum tubes moving down and tank leakage.
5. The getter of glass vacuum tube tail should remain clear at any time. Mist indicates that gas enters the vacuum heater tube. Then please change the tube.
6. The air vent in the tank couldn’t be blocked up at any time, or the tank would be damaged for swelling and sucking.
7. Keep the tank full when it’s windy, stop using it when it’s thundering. As to the tank with electric heater, we must cut off power before bathing.
8. Pay attention to the heat preservation in the water.
9. Dust will decrease the transmission rate, so clean up the dust on the vacuum tube and reflection foil regularly.
10. The special foot of frame should be fixed firmly against the strong wind.
11. Don’t change the structure of the water heater at will.